User manual

Network Dial-Out Access 6-

Or from the WIN95 Run dialog box, type in the Open field:

telnet 199.56.203.5 6666

You’ll be prompted for login and password and after a moment

you can issue AT commands to the modem.

Note: Callers with the data value auth=off are not prompted to

For example:

atdt18479825092

Note: The modem LED lights only when you dial out, not before.

Editing Network Service

You can change network service values using the set network

service command. But two caveats apply:

• Some DATA parameters may be lost when you reissue the

set network service command. So re-enter any unsaved

options.

• Before using the set network service command, you must

first disable the network service. Enable the network service

again once the change is made. The network service is

enabled by default when you add it. To disable the service:

disable network service

<service_name>

To enable network service, type:

enable network service

<service_name>

Note: You cannot change the service name using the set

network service command. To change the service name, you

must delete the network service using the delete network

service command and add it again with the new service name.