User manual

5-20 Network Dial In Acces
s
• All necessary protocols are enabled
• All other settings remain at factory defaults
Configuring User_A
To configure User_A:
1.
Add a user called "User_A" that is a network/callback user
type (the password is the same as the user name):
add user User_A password User_A type network,callback
Note: The default network service for any network user that you
add is PPP. Therefore, there is no need to set the network
service parameter for this user.
2.
Enter the phone number at which the NETServer calls the
user back:
set user User_A phone [phone]
3.
User_A's home PC has an IP address configured on it. The
NETServer will detect this address by setting the address
selection method to negotiate:
set network user User_A address_selection negotiate
4.
Save the changes to flash memory. Type:
save all
Note: By default, the NETServer will autodetect the
authentication method the remote computer is using (CHAP or
PAP). The NETServer will first attempt CHAP, then PAP
authentication. If the remote computer does not support one of
these methods, the call will be dropped.
Configuring User_B
User_B's configuration is simple, since he uses the NETServer
defaults to connect remotely. To configure User_B: