User manual

Network Dial In Access 5-1
9
Change the authentication setting by typing:
set ppp receive_authentication
[chap | pap | either | none]
Phone Number
If the network user is a callback user, use the following
command to set the user's phone number. Note: this value does
not apply to other dialin users.
set user
<name>
phone_number
<number>
Remote Access Case Study
In this case study, three network users are configured, one for
each protocol supported by the NETServer. The following table
lists the users we will create and provides a profile of each user.
User
Name
Profile
User_A
This IP user connects the NETServer using PPP.
After this user dials in and is authenticated using
CHAP, the call is disconnected and the user is
dialed back by the NETServer. This user's IP
address is negotiated.
User_B
This IPX user connects to the NETServer using
PPP and is authenticated using PAP. Once
authenticated, this user's IPX address is selected
from a pool.
User_C
This AppleTalk user connects to the NETServer
using ARAP, and is authenticated locally. This
user needs access to all AppleTalk zones on the
LAN.
Assumptions
This case study assumes the following:
• The NETServer has the correct IP address and netmask
• IP, IPX, and AppleTalk networks have been configured