Technical data
Table Of Contents
- Professional Access Point Administrator Guide
- Contents
- About This Document
- Getting Started
- Web User Interface
- Basic Settings
- Navigating to Basic Settings
- Review / Describe the Access Point
- Provide Administrator Password and Wireless Network Name
- Set Configuration Policy for New Access Points
- Update Basic Settings
- Summary of Settings
- Basic Settings for a Standalone Access Point
- Your Network at a Glance: Understanding Indicator Icons
- Cluster
- Status
- Advanced
- Basic Settings
- Command Line Interface
- Troubleshooting
- Regulatory Information
- U.S. Robotics Corporation Two (2) Year Limited Warranty
- Glossary
- Index
Professional Access Point
Administrator Guide
Events - 81
4. Restart the syslog server by typing the following at the command line prompt:
/etc/init.d/sysklogd restart
Enabling and Disabling the Log Relay Host on the Status Menu’s Events Page
To enable and configure log relaying on the Status menu’s Events page, set the log relay options as
described below.
Update Settings
To apply your changes, click Update.
If you enabled the log relay host, clicking Update will activate remote logging. The access point will send its
kernel messages real-time for display to the remote log server monitor, a specified kernel log file, or other
storage, depending on how you configured the log relay host.
If you disabled the log relay host, clicking Update will disable remote logging.
Note
The syslog process will default to use port 514. USRobotics recommends using this default port.
However, if you choose to reconfigure the log port, make sure that the port number that you assign to
syslog is not being used by another process.
Field Description
Log Relay Host Enabled Choose to either enable or disable use of the Log Relay Host:
• Enabled
• Disabled
If you select Enabled, the Relay Host and Relay Port fields are editable.
Relay Host Specify the IP Address or DNS name of the relay host.
Relay Port Specify the port number for the syslog process on the relay host.
The default port is 514.