Technical data
Table Of Contents
- Professional Access Point Administrator Guide
- Contents
- About This Document
- Getting Started
- Web User Interface
- Basic Settings
- Navigating to Basic Settings
- Review / Describe the Access Point
- Provide Administrator Password and Wireless Network Name
- Set Configuration Policy for New Access Points
- Update Basic Settings
- Summary of Settings
- Basic Settings for a Standalone Access Point
- Your Network at a Glance: Understanding Indicator Icons
- Cluster
- Status
- Advanced
- Basic Settings
- Command Line Interface
- Troubleshooting
- Regulatory Information
- U.S. Robotics Corporation Two (2) Year Limited Warranty
- Glossary
- Index
Professional Access Point
Administrator Guide
Class Structure, Commands, and Examples - 249
• Example 1: At a blank command line, hit TAB twice to get a list of all commands.
USR5453-AP#
add Add an instance to the running configuration
factory-reset Reset the system to factory defaults
get Get field values of the running configuration
reboot Reboot the system
remove Remove instances in the running configuration
save-running Save the running configuration
set Set field values of the running configuration
• Example 2: Type "get " TAB TAB (including a space after get) to see a list of all field options for the get
command.
USR5453-AP# get
association Associated station
basic-rate Basic rate of the radio
bridge-port Bridge ports of bridge interfaces
bss Basic Service Set of the radio
cluster Clustering-based configuration settings
cluster-member Member of a cluster of like-configured access points
config Configuration settings
detected-ap Detected access point
dhcp-client DHCP client settings
dot11 IEEE 802.11
host Internet host settings
interface Network interface
ip-route IP route entry
klog-entry Kernel log entry
log Log settings
log-entry Log entry
mac-acl MAC address access list item
ntp Network Time Protocol client
portal Guest captive portal
radio Radio
radius-user RADIUS user
ssh SSH access to the command line interface
supported-rate Supported rates of the radio
system System settings
telnet Telnet access to the command line interface
tx-queue Transmission queue parameters
wme-queue Transmission queue parameters for stations
• Example 3: Type "get system v" TAB. This will result in completion with the only matching field, "get sys-
tem version". (Hit ENTER to get the output results of the command.)
USR5453-AP#
get system v
USR5453-AP#
get system v
ersion
• Example 4: Type "set" TAB TAB (including a space after set) to get a list of all field options for the set
command.
USR5453-AP#
set
bss Basic Service Set of the radio
cluster Clustering-based configuration settings
cluster-member Member of a cluster of like-configured access po
config Configuration settings