User`s manual

U.S. Robotics I-modem Command Reference
Dial Security • Page 9-13
Accessing Account Information (%S)
Once Dial Security is enabled, you can access accounts by entering the local access pass-
word using the %S= command, which allows access to the accounts by disabling local
security.
AT%S=administrative password <Enter>
Note The device echoes the administrative password, which is case-sensitive.
I-modems will accept an invalid password entry, but will lock out users
from the security commands.
For example, if the password is Green, but you enter GREEN, an OK is displayed. How-
ever, if you try to type a security command (for example, ATI10 <Enter> to view
accounts), an [ ACCESS DENIED ] message is displayed.
Account Status
Once access has been granted, you can view account information by typing:
ATI10 <Enter>
Remote users may only use this command during a remote-access session if local-access
security is disabled.