User`s manual

U.S. Robotics I-modem Command Reference
Dial Security • Page 9-12
OK
Figure 9-1. The ATI10 Screen. Bold Characters Indicate the Commands Used
to Control the Adjacent Fields
7. Send ATZ or ATZ! to activate the Dial Security settings!
Note Make sure that DIP switch 1 is ON, which tells the I-modem to load the
settings stored in NVRAM
. If DIP switch 1 is OFF, the settings in ROM
(&F0) are loaded, disabling Dial Security. You can retrieve the Dial Secu-
rity settings by setting DIP switch 1 ON and then resetting the I-modem
using ATZ or ATZ! or by powering off the I-modem and powering it back
on.
Maintaining Security Accounts
Once the administrative password is set and Dial Security is enabled, the administrator is
the only one who can access account information.
To modify or change account information, use the %S= and %E= commands described on
the next page.