User`s manual

U.S. Robotics I-modem Command Reference
Remote Access • Page 8-10
Note Even though, by default (%C0), the changes you make do not take effect
until the next connection, the new conÞgu-ration is reßected immediately
in inquiry responses (ATIn).
%C1 Restore the original conÞguration. Use this command to cancel any
changes made during remote access and restore the original conÞguration.
Note Commands that have been written to NVRAM
(using &W) and forced con-
Þguration changes (using %C2) will not be restored to their previous set-
tings when you send the host %C1.
%C2 Force conÞguration changes. Use this command to make conÞguration
changes take effect immediately. We do not recommend forcing changes
unless it is absolutely necessary because an unreliable connection, or even
a loss of connection, may result.
After you make changes to the hostÕs conÞguration, the remote- access prompt changes
from Remote-> to Remote+>.
If you restore the original conÞguration using %C1, the top prompt is restored, assuring
you the original conÞguration is intact.