User`s manual

U.S. Robotics I-modem Command Reference
Working with Memory • Page 4-19
&W To substitute a template other than &F1, write the desired template to NVRAM
using the &W command.
AT&F2&W <Enter>
To modify the &Fn conÞguration in NVRAM, type your changes afterward and then save
them to NVRAM, as in the following example (the original factory template remains
intact):
ATS10=40&A2&W <Enter>
Resetting I-modems
Z or Z!Resets and loads the NVRAM settings when DIP switch 1 is ON (factory setting).
If DIP switch 1 is OFF, the I-modem resets and loads the &F0 conÞguration tem-
plate (no ßow control). Use ATZ or ATZ! to make changes to the DIP switch set-
tings take effect immediately.Table 4-5. &F0 No Flow Control Template