User`s manual

U.S. Robotics I-modem Command Reference
Working with Memory • Page 4-16
Speaker control M1 ON during dial through con-
nect
Result codes Q0 Enabled
Verbal or numeric result codes V1 Verbal result codes
Result code subset X1 Basic
Protocol response codes &A3 Full protocol codes
Serial port rate select &B1 Serial port rate Þxed higher
than connect rate
Guard tone &G0 U.S./Canada
Transmit data hardware ßow control &H0 Disabled
Rec'd data software ßow control &I0 Disabled
Analog data compression &K1 Enabled
Normal or leased lines &L0 Normal lines
Error control/sync &M4 Normal/error control
Link rate select &N0 Variable
Rec'd data hardware ßow control &R1 Disabled
Data Set Ready &S0 Always on
Table 4-5. &F0 No Flow Control Template
NVRAM Options Setting Description