User`s manual

U.S. Robotics I-modem Command Reference
Working with Memory • Page 4-13
* Detected by each I-modem from the AT preÞx of the &W com-mand that writes your defaults
to NVRAM. Set your software to the desired word length, parity, and serial port rate defaults
before sending the modem the AT É&W string.
DTE rate* (Kbps) 19.2 _
Table 4-4. &F2 Software Flow Control Template
NVRAM Options Setting Description
Handshake option B0 ITU-T answer sequence
Transmitter C1 Enabled
Command mode echo E1 Enabled
Online local echo F1 Disabled
Training tone volume L2 Medium
Speaker control M1 ON during dial through con-
nect
Result codes Q0 Enabled
Verbal or numeric result codes V1 Verbal result codes
Table 4-3. &F1 Hardware Flow Control Template
NVRAM Options Setting Description