User`s manual

U.S. Robotics I-modem Command Reference
Working with Memory • Page 4-10
Working with Flash Memory
The I-modem permanently stores three conÞguration Òtemplates,Ó or prepared sets of com-
mands, in Flash memory. You can retrieve a template and load it into current memory
using the &Fn command.
&Fn Load one of the three conÞguration templates from Flash memory into current
memory.
&F0 No ßow control (low performance).
&F1 Hardware ßow control.
&F2 Software ßow control.
All of the settings in each template are given in Table 4-3, 4-4, and Table 4-5. The settings
that change from template to template appear in bold type.
If DIP switch
1 is OFF when you power on or reset the I-modem, or if you load template
&F0, the &F0 settings take effect (see Table 4-5).