User`s manual

U.S. Robotics I-modem Command Reference

Appendix A: Alphabetic Command Summary • Page A-34

3 8 On DTR signal, autodial the number stored in

NVRAM

at position 0 (external I-modem only).

4 16 At power-on/reset, autodial number stored in

NVRAM at position 0.

5 32 Disable HST (used for testing V.32terbo in Dual Stan-

dard I-modems).

6 64 Disable MNP Level 3 (used for testing Level 2).

7 128 Hardware reset (works like powering off and then

on).

S14 1 Bit-mapped register. (See Chapter 1, Using the A

T Command Set, for

instructions about how to set bit-mapped registers.)

Bit Value Result

0 1 Disconnect on escape code.

1 2 Send result codes only when originating a call.

S15 0 Bit-mapped register. (See Chapter 1, Using the A

T Command Set, for

instructions about how to set bit-mapped registers.)

Table AÐ1. S-registers: Their Functions and Default Settings