User`s manual

U.S. Robotics I-modem Command Reference

Appendix A: Alphabetic Command Summary • Page A-33

S8 2 Sets the duration, in seconds, for the pause (,) option in the Dial command

and the pause between command reexecutions (> and A> commands).

S9 6 Sets the required duration, in tenths of a second, of the remote device's car-

rier signal before recognition by the I-modem.

S10 7 Sets the duration, in tenths of a second, that the I-modem waits after loss of

carrier before hanging up. This guard time allows the I-modem to distinguish

between a line hit, or other disturbance that momentarily breaks the con-

nection, from a true discon-nect (hanging up) by the remote device

S11 70 Sets the duration and spacing, in milliseconds, of dialed tones.

S12 50 Sets the duration, in Þftieths of a second, of the guard time for the escape

code (+++) sequence.

S13 0 Bit-mapped register. See Chapter 1, Using the A

T Command Set, for

instructions about how to set bit-mapped registers.

Bit Value Result

0 1 Reset when DTR drops.

1 2 Reverse normal Auto Answer operation: On incom-

ing RING, enter Originate Mode and look for an

answer tone.

2 4 Disable 250 ms pause before result code display.

Table AÐ1. S-register

s: Their Functions and Default Settings