User`s manual

U.S. Robotics I -modem Command Reference
Using the AT Command Set • Page 1-1
Chapter 1
Using the AT Command Set
I-modems are controlled using AT commands.
To send AT commands to the I-modem, connect a computer with an EIA-232 serial port to
the I-modemÕs serial port. The computer must be running a communications software
package.
Before you can send any AT commands to your I-modem, you need to put your communi-
cations software in T
erminal mode. In Terminal mode, what you type is sent directly to the
I-modem.
General Rules for Using AT Commands
¥ Type AT before each command and press <Enter>
1
after each command. Exceptions:
A/ , A> , and +++ , which require neither AT nor <Enter> .
1. Angle brackets (< and >) are used in this manual to indicate the name of a key. Do not type the angle
brackets when issuing a command.