Specifications

TechMemo 01-0011B August 26, 2004
3 of 24
3. Start AlphaNET Diagnostics software:
4. When the Diagnostics screen appears, click Modem. Then make the following selections:
5. Click Configure Modem. One of the following two messages will appear:
• Modem Configured Properly — The transmitting modem is ready for use. It can now be connected to a
phone line. If the receiving modem inside the sign has been set up and connected to a phone line, go to
“Modem test” on page 7. Otherwise, go to “Receiving modem setup for AlphaEclipse outdoor signs”
on page 4.
• Modem Failed To Configure — Make sure that the modem is on and is connected to the correct COM
port on the computer. Repeat step 4, but this time watch the RD and SD lights on the modem. These
lights should flash when you click Configure Modem. If the “Modem Configured Properly” message
still does not appear, contact Adaptive Technical Support (800-719-2838).
Com Port Connected to Modem = the
computer COM port where the
modem is connected.
Baud Rate = 9600.
Data Format = 8,N,1.
Dialing Prefix = if a number, like 9, is
needed to get to an outside phone
line, enter the number here.
Number to Dial = the receiving
modem’s phone number.
Timeout (in Seconds) = 30
Configuration String =
AT&H0&R1&B1&N6&Y0&W0 (see
“Modem setup configuration string”
on page 24 for more information)
Figure 3: AlphaNET modem setup