Specifications
TechMemo 01-0011B August 26, 2004
17 of 24
In
Displays modem information:
• I0 — 4-digit product code.
• I1 — results of ROM checksum.
• I2 — results of RAM checksum.
• I3 — product type and firmware revision (for example, U.S. Robotics 56K FAX EXT V5.2.9).
• I4 — current modem settings.
• I5 — NVRAM settings for templates Y0 and Y1.
• I6 — link diagnostics.
• I7 — product configuration (see example below):
• I9 — plug-and-play information.
• I11 — extended link diagnostics.
Ln
Sets speaker volume (internal modems only):
• L0 — low volume.
• L1 — low volume.
• L2 — medium volume.
• L3 — high volume.
Mn
Operates modem speaker:
• M0 — speaker always off.
• M1 — speaker on until connect.
• M2 — speaker always on.
• M3 — speaker on after dial until connect.
On
Returns online. Use with the escape code +++ to toggle between command and online modes:
• O0 — return online (normal).
• O1 — return online and retrain.
Qn
Enables or disables the display of result codes (also controlled by DIP switch #3):
• Q0 — display result codes.
• Q1 — suppress results codes.
Vn
Displays result codes in words or numbers (also controlled by DIP switch #2):
• V0 — use numeric codes.
• V1 — use words.
Xn
Controls the amount of information displayed in a result code:
• X0 — basic result codes: only use result codes 0 through 4 which are OK, CONNECT, RING, NO CARRIER, and ERROR.
Does not look for dial tone or busy signal.
• X1 — extended result codes (CONNECT speed codes). Does not look for dial tone or busy signal.
• X2 — extended result codes with NO DIAL TONE. Does not look for busy signal.
• X3 — extended result codes with BUSY. Does not check for dial tone.
• X4 — extended result codes with NO DIAL TONE and BUSY.
Yn
Selects power up/reset modem configuration. This works with DIP switch #7:
• Y0 — user-defined template 0.
• Y1 — user-defined template 1.
• Y2 — factory template 0 (generic). See also the &F0 command.
• Y3 — factory template 1 (hardware). See also the &F1 command.
• Y4 — factory template 2 (software). See also the &F2 command.
Command Function
Product type US/Canada External
Product ID: 00568604
Options V32bis,V.80,V.34+,x2,V.90,V.92
Fax Options Class 1/Class 2.0
Line Options Caller ID, Distinctive Ring
Clock Freq 92.0Mhz
EPROM 256k
RAM 32k
FLASH date 2/16/2001
FLASH rev 5.2.9
DSP date 2/16/2001
DSP rev 5.2.9