Specifications

TechMemo 01-0011B August 26, 2004
11 of 24
5. Select COM1 from the next screen and click OK:
6. When the next window appears, set the communication parameters as shown below. Then click OK.
7. In the terminal window, type the command “ate1” (all lowercase) and then press the ENTER key:
NOTE: When typing commands, either use all lowercase (as above) or all uppercase letters. Mixing lower-
and uppercase letters in a command may cause an error.
The baud rate (Bits per second)
is set high (57600) because the
modem will be communicating
with a computer not a sign.
ate1 is called an “at command”:
• at = These two letters start most modem commands.
• e1 = The actual command. For a US Robotics Faxmodem,
this command tells the modem to display what you type.
Otherwise, you could not see the letters as you type.