Specifications

August 26, 2004 TechMemo 01-0011B
10 of 24
Advanced modem setup using Hyperterminal
Use this section when AlphaNET Diagnostics software is not available for modem setup or when greater
control is needed for modem setup.
NOTE: The AT commands used in this section only apply to US Robotics 56K V.90 and V.92 Faxmodems.
Though some of the AT commands used below might work with other modems, consult your
modem’s documentation for a list of AT commands specific to your modem.
Set up Hyperterminal
1. Set the DIP switches on a US Robotics 56K Faxmodem as shown in Figure 1 on page 2.
2. Connect the modem to your computer as shown in Figure 2 on page 2. Then turn the modem on.
3. Start Hyperterminal:
4. A “New Connection” must be created the first time Hyperterminal is used with a modem. When the
Connection Description window appears, type “Modem” after Name. Then click OK:
NOTE: Next time you open Hyperterminal, click Cancel at this window. Then click File > Open and select
Modem.ht.