User`s guide

TECHNICAL REFERENCE
70
&In Sets Receive Data (RD) software
flow control, see also &Rn
&I0 Software flow control disabled
&I1 Xon/Xoff signals to your modem
and remote system
&I2 Xon/Xoff signals to your
modem only
&Kn Enables/disables data
compression
&K0 Data compression disabled
&K1 Auto enable/disable
&K2 Data compression enabled
&K3 MNP5 compression disabled
&Mn Sets Error Control (ARQ) for
connections at 1200 bps and higher
&M0 Normal mode, error control
disabled
&M1 Reserved
&M2 Reserved
&M3 Reserved
&M4 Normal/ARQ
&M5 ARQ mode
&Nn Sets connect speed, if connection cannot
be made at this speed, the modem will
hang up. When used in conjunction
with &Un and &Un is greater than 0,
&Nn sets the ceiling connect speed.
&Un sets the floor connect speed. (See
also the table in the &Un section.)
Note: &N17 through &N39 apply only to
V.90 products.
&N0 Connection speed is determined
by the remote modem
&N1 300 bps
&N2 1200 bps
&N3 2400 bps
&N4 4800 bps
&N5 7200 bps
&N6 9600 bps
&N7 12,000 bps
&N8 14,400 bps
&N9 16,800 bps
&N10 19,200 bps
&N11 21,600 bps
&N12 24,000 bps