User`s guide

66 56K Message Modem
Fax Commands
FCLASS=n Sets the mode of operation
FCLASS=0 Data mode
FCLASS=1 Group 3 Facsimile Service Class 1
mode
FCLASS=2.0 Group 3 Facsimile Service Class 2.0
mode
FCLASS? Displays the current FCLASS mode
(See mode descriptions above)
+FCLASS=? Displays the FCLASS mode options
(See mode descriptions above)
+FTS=n Stops the fax transmission. Then the modem waits
for a specified time before OK appears on screen.
The pause is set in 10 millisecond intervals. n is the
number of 10 millisecond intervals that pass before
OK appears. (n=0-255)
+FRS=n Makes the modem wait for a specified length of
silence before sending OK to the screen. The pause
is set in10 millisecond intervals. n is the number of
10 millisecondintervals that pass before OK
appears.(n=0-255) Note: This command terminates
with OK when either the specified amount of silence
is detected or when the user types anything (which
is ignored).
+FTM=n Transmits data using the modulation specified by
n.(n = 3, 24, 48, 72, 96, 97, 98, 121, 122, 145, or 146)
Note: See the “Screen Messages” table at the end
of thissection for an explanation of messages that
appear in response to this command.
+FRM=n Receives data using the modulation specified by
n.(n = 3, 24, 48, 72, 96, 97, 98, 121, 122, 145,
or 146) Note: See the “Screen Messages”
table at the end of this section for an explanation of
messages that appear in response to this command.