User`s guide

54 56K Message Modem
&Hn Sets Transmit Data (TD) flow control. See also
&Rn.
&H0 Flow control disabled
&H1 Hardware flow control, Clear to Send (CTS)
&H2 Software flow control, XON/XOFF
&H3 Hardware and software flow control
&In Sets Receive Data (RD) software flow control. See
also &Rn.
&I0 Software flow control disabled
&I1 XON/XOFF signals to your modem and remote
system
&I2 XON/XOFF signals to your modem only
&Kn Enables/disables data compression.
&K0 Data compression disabled
&K1 Auto enable/disable
&K2 Data compression enabled
&K3 MNP5 compression disabled
&Mn Sets Error Control (ARQ) for connections at 1200
bps and higher.
&M0 Normal mode, error control disabled
&M1 Reserved
&M2 Reserved
&M3 Reserved
&M4 Normal/ARQ
&M5 ARQ mode
&Nn Sets connect speed. If connection cannot be
established at this speed, the modem will hang up.
When used in conjunction with &Un and &Un is greater
than 0, &Nn sets the ceiling connect speed. &Un
sets the floor connect speed.. See the table in the
&Un section.
&N0 Variable rate
&N1 300 bps
&N2 1200 bps
&N3 2400 bps
&N4 4800 bps
&N5 7200 bps
&N6 9600 bps
&N7 12,000 bps
&N8 14,400 bps
&N9 16,800 bps