User`s guide

56K Professional Message Modem 75
Fax Commands
+FCLASS=
n
Sets the mode of operation
FCLASS=0 Data mode
FCLASS=1 Group 3 Facsimile Service Class 1
mode
FCLASS=2.0 Group 3 Facsimile Service Class 2.0
mode
FCLASS?
Displays the current FCLASS mode
(See mode descriptions above)
+FCLASS=?
Displays the FCLASS mode options
(See mode descriptions above)
+FTS=
n Stops the fax transmission. Then the modem waits for
a specified time before
OK
appears on screen.
The pause is set in 10 millisecond intervals.
n
is the
number of 10 millisecond intervals that pass before
OK
appears. (
n
=0-255)
+FRS=
n Makes the modem wait for a specified length of silence
before sending
OK
to the screen. The pause is set in 10
millisecond intervals.
n
is the number of 10 millisecond
intervals that pass before
OK
appears.(
n
=0-255)
Note: This command terminates with
OK
when either
the specified amount of silence is detected or when the
user types anything (which is ignored).
+FTM=
n Transmits data using the modulation specified by
n
.(
n
= 3, 24, 48, 72, 96, 97, 98, 121, 122, 145, or 146)
Note: See the “Screen Messages” table at the end of
this section for an explanation of messages that appear
in response to this command.
+FRM=
n Receives data using the modulation specified by
n
.(
n
= 3, 24, 48, 72, 96, 97, 98, 121, 122, 145, or 146)
Note: See the “Screen Messages” table at the end of
this section for an explanation of messages that
appear in response to this command.