User`s guide

56K Professional Message Modem30
Troubleshooting and Online Help
Resources
TROUBLESHOOTING
PROBLEM
Your screen keeps
displaying random garbage
characters.
AND ONLINE HELP
DIAGNOSIS
You may not be entering
modem commands in the
proper manner.
You could have a conflict
with the remote modem’s
settings for word length, parity,
and stop bits.
Your software and modem
might not be set to the same
flow control settings.
The best flow control settings
might not be enabled on your
modem.
RESOURCES
POSSIBLE SOLUTION
Type in all upper case (AT) or
lower case (at).
Set your modem’s word length,
parity, and stop bits the same
as the remote modem or BBS
you are calling.
Make sure the software and
modem have the same flow
control settings (hardware
[RTS/CTS] and software
[xon/xoff]).
Type this command in terminal
mode to set hardware flow
control: AT&F1 and press
ENTER.