User`s guide

56K Professional Message Modem 29
Flow Control
• For hardware flow control (highly recommended), select RTS/CTS.
• For software flow control, select XON/XOFF.
NOTE 1: Disable the type of flow control (hardware or software) that
you are not using.
NOTE 2: Upon exit of the non-supplied software, execute the
supplied application software to re-initialise all the answer machine
functionality if required.
UART - Universal Asynchronous Receiver Transmitter
If you are running Windows 3.x or you have upgraded your system from
Windows 3.x to Windows 95, you can run MSD to determine your
UART setting. In DOS, type MSD at the Windows directory and then
press ENTER.
Follow the on-screen instructions to access the COM port settings
panel. In this panel you should find the UART chip used. Match the
UART type listed in MSD with the serial rate listed in the chart. Select
this serial rate in any fax/data programs you use.
If this is your UART... Select this serial rate
16550 115.2 or 57.6 Kbps
16450 38.4 Kbps
8250 19.2 Kbps
NOTE: Do not select a 28,800, 14,400, or 12,000 bps serial port rate
if offered. Your modem will not work correctly with any of these
settings. Fix or lock the serial port (baud) rate. If it’s referred to as
autobaud, select OFF.