Operating instructions

LIFEPAK 500 Automated External Defibrillator Operating Instructions 4-5
©1996–2003 Medtronic Physio-Control Corp.
Data Management
4 Data Management
Setup Options
Make sure that the AED setup options are properly defined for the modem initialization string and
destination phone number. Refer to page 2-7 for information about the modem setup options.
Note: Remember to include in the dial string any special characters that are required to dial the
destination (such as “9” or a pause).
Procedure for Sending Data
Perform these steps to send the data:
1 Make sure that the equipment at the destination site is properly connected.
2 Make sure that the destination computer power is on and that the QUIK-VIEW 500 data review
program or CODE-STAT Suite program is ready to receive data.
3 Make sure that the modem is off and that the AED is turned off for at least 60 seconds.
4 At the local site, connect the equipment as shown in Figure 4-4.
• Connect the modem cable to the AED and the modem.
• Connect the telephone cord to the modem and the analog telephone line.
• Connect the modem power cord or power adapter to a power source (if required).
Figure 4-4 Equipment connections for data transfer by modem
5 Turn on the modem.
6 Press
ON/OFF to turn on the AED. You will see:
BATTERY status message
SELF-TEST xx.xx message
Required Resources at Destination Site
Modem that supports the Hayes AT command set
Personal Computer:
– QUIK-VIEW 500 data review program or CODE-STAT Suite data
management system
– Microsoft Windows 3.1 or later for Data Transfer 500, and for
QUIK-VIEW 500 if audio review is not needed. Microsoft Windows 95
for QUIK-VIEW 500 if audio review is needed
– Microsoft Windows 95 or Windows NT 4.0 for CODE-STAT Suite 3.2
or earlier and Windows 98, Windows ME, Windows 2000
Professional, or Windows NT version 4.0 with Service Pack 1 for
CODE-STAT Suite 4.0 or later
Cables as required
Analog telephone line
1
* Most internal telephone lines for integrated office telephone systems are digital lines. Make sure that you connect the
modem to an external analog telephone line like the type used for fax machines.
Analog telephone
outlet
Modem Cable
LIFEPAK 500 AED
Power adapter
and cord
(if required)
Modem
To power source