User manual

USING SPOTCELL VIEWER
SpotCell Viewer 2 17
To change the CU dial out number
1.
On the Control tab, click Change Alarm Phone Number.
2. Type the new phone number.
5.3.7 CU identifiers
Each SpotCell system has two field IDs that help identify the unit when connecting to a
remote monitoring site.
To change the CU Identifiers
1.
On the Control tab, click Change Unit ID Field #1 or Change Unit ID Field #2.
2. Type any appropriate identifying text (up to 32 printable characters) in the New
Identification
field.
3. Click OK to accept the Unit ID change.
5.3.8 Acknowledging an alarm
If CU dial out is enabled, then the system will automatically dial out to a remote
monitoring site when an alarm condition is created. If the alarm condition still exists after
hanging up, then the CU will repeatedly dial out with the same alarm information.
Acknowledging the alarm will prevent the CU from dialing out until the alarm clears and
another alarm is generated.
To acknowledge an alarm
 On the Control tab, click Alarm Acknowledged.
After hanging up, the CU will not attempt to dial out (if enabled) until the alarm clears
and another alarm occurs.