User manual

USING SPOTCELL VIEWER
SpotCell Viewer 2 15
5.3 The Control Tab
The Control tab allows you to:
 force the SpotCell system to Install mode
 disable/enable dial out mode or the DU power supply
 restart the system from a known good state
 change Alarm phone numbers and Unit ID fields
 change the password (25 printable characters/case sensitive)
5.3.1 Password protection
All functions of the Control tab require a password to be entered before the command
can be completed. The password is encrypted to ensure security during remote access
to the CU.
The initial password at installation is “spotcell”.
To change the password
1.
On the Control tab, click Change Password.
2. Type the old password and new password.
The password can contain up to 25 printable characters and is case sensitive.
3. Confirm the new password by typing it again in the Confirm New Password field and
click
OK.