User manual

The WebMux™ Model 480S, 580SG, and 680PG User Guide – Version 7.0.x

Appendix 3 - Phone Paging Codes

When an error occurs, the WebMux™ will send an error code to the regular

numerical pager assigned in the Administration Setup page. Please refer to the

Management Browser - Administration Setup section on setting up phone pager

numbers.

To be as compatible as possible to different types of pagers, only numeric error

codes are used. The minimum requirement is the pager should be able to

display up to 18 digits. If the pager cannot display 18 digits, some codes may get

truncated.

For WebMux™ (Single and with Secondary)

• 99IIIIIIIIIIIIPPPP - A server went down. This 18-digit code (no spaces)

starts with 99 followed by 12 digits of the IP address (without the periods)

of the server. The last four digits represent the port number of the server.

• 00IIIIIIIIIIIIPPPP - A downed server went back up. This 18-digit code (no

spaces) starts with 00 followed by 12 digits of the IP address (without the

periods) of the server. The last four digits represent the port number of

the server.

• 98////////////[PPPP] – Gateway (router LAN) does not respond. 12 digits

number after the 98 is the IP address of the gateway. Port number is

optional.

• 01////////////[PPPP] – Gateway comes back in service. 12 digits number

after the 01 is the IP address of the gateway. Port number is optional.

• 88////////////PPPP – WebMux™ has detected more connections than the

threshold defined in the setup screen.

• 40 - last resort servers taken out of service for a farm.

• 41 - last resort servers put in service for a farm.

• 73 - WebMux™ cannot reach to the back LAN.

• 74 - WebMux™ cannot reach the front LAN.

• 75 - Primary or Secondary cannot reach the other WebMux™ through

the serial cable.

• 76 - Serial cable communication restored.

• 55 - User configuration cannot be parsed by WebMux™ (after the

configuration restored through browser).