User manual

The WebMux™ Model 480S, 580SG, and 680PG User Guide – Version 7.0.x

These IP addresses cannot be your Internet registered addresses. They must be

Internet non-routable. For example, you can assign addresses in a 10.0.0.0

network address range, or a 192.168.199.0, etc.

Enter Server LAN Network IP Address Mask:

This is the network mask of the Server LAN. For a class A network, it may be

255.0.0.0. For a class C network, it may be 255.255.255.0.2

Enter Server LAN Gateway IP address:

This IP address will be the Default Gateway entry for all the servers on the

Server LAN. In an installation with two WebMuxes, if a gateway IP address of

10.1.1.1 is used, this address will ‘float’ between the primary and secondary

WebMux™. If the Primary went down, the 10.1.1.1 address will float to the

backup.

In the single WebMux™ setup, this address CANNOT be the same as the

WebMux™ IP interface address on the Server LAN. For the NAT setup, please

continue to the

Common Configuration section.

Trasnparent Mode Related Configuration

Enter Bridge IP Address:

This will be the IP address of the WebMux™ on the network so that you can use

browser to manage it. Although the “server” and “internet” ports are

interchangeable in transparent mode, it is recommended that you stick with

labeling scheme and connect the port labeled “internet” to the switch on the

firewall/router side and connect switch on the servers to the port labeled “server”.

Enter Bridge Net Mask:

This should match the net mask of the existing network the WebMux™ will be a

part of.