User manual

The WebMux™ Model 480S, 580SG, and 680PG User Guide – Version 7.0.x
• Connect the WebMux™(es) to the Router LAN (NAT and Transparent
mode).
• Power up all devices in the network.
• Verify that all the devices are up and running.
• You are now ready to configure WebMux™.
Hardware Setup ---Configuration Summary
CAUTION: Do not proceed without collecting all necessary information.
• Turn on the WebMux™. Turn on the switch on the back of the WebMux™
and push the power-on button in the front momentarily. You will see the
version number like this:
•
After self-test, hold down the Check-Mark button on the WebMux™ until
the LCD displays the first question – “Enter WebMux host name”.
•
During the initial configuration, you will be asked to provide names and IP
addresses. (See next section.) Each item is explained in the order it is
asked.
•
Answer the questions. Reboot. Note: When reboot is complete, the
service statistics screen will appear.
•
Run the Management Browser.
Initial Configuration
Enter WebMux™ Host Name:
Copyright© 1997-2006 CAI Networks, Inc.
20