User guide

- 5 -
Section 1
Main Components
1.1 Front View
1.1.1 Toggle Power Switch
This switch toggles power on and off. To power off, the switch must be pressed and held for
5 seconds. However, it is recommended that you do not regularly use this power switch to
shut down the unit. Please use the LCD panel, web interface, or command line interface to
issue a proper shut down.
1.1.2 Reset Button
Press and release the reset button to reboot the WebMux. This is a hard reboot, not a factory
reset. This will not reset your settings. Please allow several minutes for the WebMux to
completely reboot.
1.1.3 Up Arrow Button, Down Arrow Button
When each button is pressed, the value on the cursor location increases or decreases. It goes
through lower case letters, upper case letters, numbers and symbols. When the cursor is
located at the left most position on the LCD, the up and down arrow allows the user to select
a different item to setup.
1.1.4 Left Arrow Button and Right Arrow Button
When each button is pressed, the cursor moves to the left and right.
1.1.5 Check Mark Button, and Cross Button
Check Mark Button confirms the selection, Cross Button cancels the selection. At any time
when the system is running holding down to the Check Mark Button will invoke the
configuration menu, where you can change IP addresses and other settings.