User guide

- 84 -
Webserver(s) Default Gateway 10.1.1.1
Web Site IP Address 10.1.1.200/255.255.0.0
Configuration After WebMux Installation
Question Entry
Host Name webmux
Domain Name cainetworks.com
NAT, Transparent, Single Network or Out-of-Path Out-of-Path
WebMux Server LAN Information
Server LAN WebMux IP Address 10.1.2.254 (any)
Server LAN WebMux IP Address Mask 255.255.0.0
Server LAN WebMux farm IP Address 10.1.1.200
Server LAN VLAN ID (optional) 102
Server LAN gateway IP address
(Necessary for WebMux SSL termination and for Layer 7
load balancing. Each server’s default gateway needs to be
set to this IP)
10.1.1.253
Server Configuration
Server IP address No Change
Server NetMask No Change
Server Default Gateway No Change
Server Default Gateway
(If using WebMux for SSL Termination or Layer 7
load balancing)
10.1.1.253
Server add loopback adapter 10.1.1.200
Route Deletion Refer to Appendix B 10.1.1.200
Administration Setup Information
WebMux External Gateway IP address 10.1.1.1
Remake /home/WebMux/conf/passwd Y
Administration HTTP Port Number 24
Secure Administration HTTPS Port Number 35
Is this WebMux primary Y
WebMux running solo without backup Y
Reboot? Y
There is no change to each server’s IP address, netmask and gateway address (except if using
the WebMux for SSL termination or Layer 7 load balancing. See next paragraph). You will
need to add a loopback adapter to each server, and assign the farm address to the loopback
adapter. For MS Windows, it always adds a route for the loopback adapter, which will need
to be removed, please refer to Appendix B. In the virtual farm, add each server using its real
IP address.
For SSL termination or Layer 7 load balancing, you must set server LAN gateway IP address
and set the servers’ default gateway to that IP.