User guide

- 32 -
port collision in case passive FTP is one of the other farms. Using port number below 1024
will not require setting up an “admin farm IP.”
Discard Changes Made?
If you select Yes at this point, all the changes made will be discarded and you will exit the
setup mode. By default the answer is NO; all the changes will be saved. Only when you select
NO (do not discard changes), changes will be saved to the internal solid state storage.
Changes will take effect after next reboot.
The next question will be Reboot Now?
Reboot Now?
This is the end of initial configuration. Most of the setup or changes require a reboot to take
effect. Press and hold the center Check-Mark button to make the WebMux reboot. Use the
UP arrow button to return to “Discard Changes” and select “Yes” to exit without change.
Press the DOWN arrow or Cross Button to continue to the Factory Reset option (see Factory
Reset below).
After the WebMux is rebooted, the statistics of the incoming packets, outgoing packets, etc
will be displayed on LCD periodically.
Power Off:
Pressing the “down” button at the “Reboot?” screen will bring you to the “Power Off” screen.
We recommend that you always power down the WebMux via the LCD panel, Web GUI, or
Command Line Interface. If at all possible, avoid powering off the unit using the switch on
the front or back of the unit.