User guide

- 28 -
Enter Server LAN Gateway IP address:
This IP address is on WebMux. It will be the Default Gateway entry for all the servers on the
Server LAN. This address will ’float’ between the primary and secondary WebMux. If the
Primary went down, the address entered here will float to the backup. Please pay very careful
attention that THIS IS NOT YOUR EXTERNAL ROUTER/GATEWAY IP. The IP address
you put here will be assigned to the Server LAN interface. Make sure it is a unique IP
address.
In the single WebMux setup, this address CANNOT be the same as the WebMux IP interface
address on the Server LAN. When configuring a backup unit, this screen will not be
displayed. Please continue to the Common Configuration section.
5.8 Transparent Mode or Single Network Mode Related
Configuration
Enter Bridge IP Address:
This will be the IP address of the WebMux on the network so that you can use browser to
manage it. Although the “server” and “internet” ports are interchangeable in transparent mode,
it is recommended that you stick with labeling scheme and connect the port labeled “internet”
to the switch on the firewall/router side and connect switch on the servers to the port labeled
“server.”
Enter Bridge Net Mask:
This should match the net mask of the existing network the WebMux will be a part of.
Enter Router LAN VLAN ID (optional):