User guide

- 24 -
• Turn on the WebMux. Turn on the switch on the back of the WebMux and push the
power-on button in the front momentarily. You will see the version number like this:
• After self-test, hold down the Check-Mark button on the WebMux until the LCD
displays the first question—“Enter WebMux host name.”
• During the initial configuration, you will be asked to provide names and IP addresses.
(See next section.) Each item is explained in the order it is asked.
• Answer the questions. Reboot.
Note When reboot is complete, the service statistics screen will appear.
• Run the Management Browser.
5.6 Initial Configuration
Enter WebMux Host Name:
Enter the host name of the WebMux. Use the right arrow to move the position, the up and
down arrows to select characters, left arrow to move back in position, check mark button to
confirm the change. This host name is for identification purposes. You may call it webmux1,
webmux2, etc. (You can hold down the up/down button for more than a second to make
quicker changes.) Note the left most down arrow on the LCD allows the user to move to other
settings.
Enter WebMux Domain Name:
This is for identification only; this has no effect for network operation. Although it can be any
name, we suggest using the primary domain name of the Router LAN network. If you have
only one domain, use that domain name. Note the left most position on the LCD has changed
to an up and down arrow, allowing the user to go back and forth for questions and answers.