User manual

TECHNICAL REFERENCE
8-21
Fax Commands
+FCLASS=n Sets the mode of operation.
FCLASS=0 Data mode
FCLASS=1 Group 3 Facsimile Service Class 1 mode
FCLASS=2.0 Group 3 Facsimile Service Class 2.0 mode
FCLASS? Displays the current FCLASS mode (see
descriptions above).
+FCLASS=? Displays the FCLASS mode options (see
descriptions above).
+FTS=n Stops the fax transmission. Then the
modem waits for a specified time before
OK appears on screen. The pause is set in
10 millisecond intervals. n is the number of
10 millisecond intervals that pass before
OK appears. (n=0-255)
+FRS=n Makes the modem wait for a specified
length of silence before sending OK to
the screen. The pause is set in 10
millisecond intervals. n is the number of 10
millisecond intervals that pass before OK
appears. (n=0-255)
Note: This command terminates with OK when
either the specified amount of silence is
detected or when the user types anything
(which is ignored).
+FTM=n Transmits data using the modulation
specified by n. (n = 3, 24, 48, 72, 96, 97,
98, 121, 122, 145, or 146)
Note: See the “Screen Messages” table at the
end of this section for an explanation of
messages that appear in response to this
command.
+FRM=n Receives data using the modulation
specified by n. (n = 3, 24, 48, 72, 96, 97,
98, 121, 122, 145, or 146)
Note: See the “Screen Messages” table at the
end of this section for an explanation of
messages that appear in response to this
command.
+FTH=n Transmits data framed in the HDLC
protocol using the modulation specified
by n. (n = 3, 24, 48, 72, 96, 97, 98, 121,
122, 145, or 146)
Note: See the “Screen Messages” table at the
end of this section for an explanation of
messages that appear in response to this
command.
+FRH=n Receives data framed in the HDLC
protocol using the modulation specified
by n. (n = 3, 24, 48, 72, 96, 97, 98, 121,
122, 145, or 146)
Note: See the “Screen Messages” table at the
end of this section for an explanation of
messages that appear in response to this
command.