User manual

TECHNICAL REFERENCE

S Registers

Note: To change a setting use ATSr=n, where r is the register and n is a decimal value from 0 − 255 (unless otherwise indicated).

8-18

S32 2 Bit-mapped register setup. To set the register, see the instructions for S13.

Bit Value Result

0 1 V.8 Call Indicate enabled.

1 2 Enables V.8 mode.

2 4 Reserved.

3 8 Disable V.34 modulation.

4 16 Disable V.34+ modulation.

5 32 Disable x2 modulation.

6 64 Disable V.90 modulation.

7 128 Reserved

S33 0 Bit-mapped register setup. To set the register, see the instructions for S13.

Bit Value Result

0 1 Disable 2400 symbol rate.

1 2 Disable 2743 symbol rate.

2 4 Disable 2800 symbol rate.

3 8 Disable 3000 symbol rate.

4 16 Disable 3200 symbol rate.

5 32 Disable 3429 symbol rate.

6 64 Reserved

7 128 Disable shaping.