SDS

SDS: Brazing Rod USF
October 1, 2014
Page 3 of 8
SECTION 3: COMPOSITION/INFORMATION ON INGREDIENTS
IMPORTANT: This section covers the materials from which these products are manufactured. Any of the chemicals or
compounds subject to reporting under Title III, in Section 313, of the Superfund Amendments and Reauthorization Act (SARA) are
marked by the symbol #.
Exposure Limit (mg/m
3
)
INGREDIENTS
CAS NUMBER
OSHA PEL
ACGIH-TLV
Percent Ingredients (by weight)
Copper # 7440-50-8
0.1
0.2 30 – 60
Zinc # 7440-66-6
5 (as fume)
Not listed 30 – 60
Nickel #
7440-02-0
1
0.2
7 – 13
When flux coated, the constituents of the flux coating do not meet the reportable quantities under OSHA 1910.1200 Hazard
Communications Standard.
CAS / EINECS NUMBER / HAZARD CLASSIFICATION FOR ABOVE INGREDIENTS
Exposure limits are subject to change. Contact ACGIH and OSHA for current values. See Section 16 for European Council
Directive 67/548/EEC R-phrases and S-phrases
SECTION 4: FIRST AID MEASURES
EMERGENCY & FIRST AID PROCEDURES: Call for medical aid and inform them of the ingredients from Section 3. Employ
first aid techniques recommended by The American Red Cross.
EYES: Flush with a large amount of fresh water for at least 15 minutes. Get medical attention.
SKIN: Wash affected area with soap and water to remove dust or particles. If rash develops, see a physician. Get medical
attention for irritations that persist.
INGESTION: Seek medical attention immediately.
INHALATION: Remove to fresh air. If breathing is difficult administer oxygen. If breathing has stopped, begin artificial
respiration and obtain medical assistance immediately.
GENERAL: Move to fresh air and call for medical aid.
INGREDIENTS
CAS NUMBER
EINECS NUMBER
Hazard Classification per
ECD 67/548/EEC
Copper #
7440-50-8
231-159-6
no
Zinc # 7440-66-6 231-175-3 no (Zn in solid article form)
Nickel #
7440-02-0
231-111-4
Carc. Cat. 3; R40 - T; R48/23 - R43