User manual

DS1093-039 53
11.2 CONFIGURING PTZ SETTINGS
Settings for a PTZ camera must be configured before it can be used. Before proceeding, verify that the PTZ and RS-485
of the DVR are connected properly.
To configure PTZ settings:
1. Enter the PTZ Settings menu by clicking Menu > Setting > PTZ. The PTZ Settings menu is shown in
Figure 2.
Figure 2. PTZ Settings Menu
2. Select channel where PTZ camera is installed next to Camera label.
3. Enter PTZ settings so it matches that of the PTZ camera.
4. Click OK button to save and exit menu.
11.3 SETTING PTZ PRESETS, PATROLS & PATTERNS
Your DVR allows you to customize presets, patrols and patterns for a connected PTZ camera.
11.3.1 UNDERSTANDING PTZ CONTROLS
Before setting presets, patrols and patterns, it’s important to understand some of the features of the PTZ control panel, shown in
Figure 3.
Figure 3. PTZ Control Interface
The controls on the PTZ panel include:
1. Directional Pad/Auto-scan Buttons: Controls the movements and directions of the PTZ. Center button is
also used to start auto-scan of PTZ.
2. Zoom: Used to zoom in and out with the PTZ.
3. Focus: Used to adjust the focus of the PTZ.
4. Iris: Used to open up or close the iris of the PTZ.
5. Speed: Adjusts the movement speed of the PTZ.
6. Light: Turns PTZ light (if applicable) on and off.
7. Wiper: Turns PTZ wiper (if applicable) on and off.
8. Zoom In: Instantly zooms PTZ in.
9. Center: Centers PTZ.