User manual

DS1093-039 49
5. Select DDNS Type. There are three different DDNS type to choose from, IpServer, PeanutHull and
DynDNS.
• IpServer: Enter Server Address for IpServer.
• PeanutHull: Enter User Name and Password obtained from the PeanutHull website (Figure 6).
• DynDNS: Enter Server Address for DynDNS (i.e. members.dyndns.org) (Figure 7). Under DVR
Domain Name, enter the domain obtained from the DynDNS web site. Lastly, enter the User Name and
Password registered in the DynDNS network.
Figure 7. DynDNS Settings
10.4 CONFIGURING AN NTP SERVER
A Network Time Protocol (NTP) Server may also be setup on your DVR to keep the date and time current and accurate.
To setup an NTP server:
1. Enter the Network Settings menu by clicking Menu > Setting > Network.
2. Select the Advanced tab.
3. Select the Set button next to NTP to enter the NTP settings menu, as shown in Figure 8.
Figure 8. NTP Settings Menu
4. Check the NTP checkbox to enable feature.
5. Set NTP settings:
• Synchronize Every: Time in minutes to synchronize with NTP server.
• NTP Server: IP address of NTP server.
6. Click OK to save and exit menu.
Note: Time synchronization interval has a range of 0-10080ms, normally 7200ms. If the DVR is used on a public
network, you should use a NTP server that has a time synchronization function, such as the server at the National Time
Center (IP Address: 210.72.145.44). If the DVR is setup in a more customized network, NTP software can be used to
establish a NTP server used for time synchronization.