User manual

DS1093-039 47
10.2 CONFIGURING PPPOE SETTINGS
Your DVR also allows for Point-to-Point Protocol over Ethernet (PPPoE) access. To set up PPPoE access:
1. Enter the Network Settings menu by clicking Menu > Setting > Network.
2. Select the General tab.
3. Set the IP address and subnet mask to 0, as shown in Figure 3. When the PPPoE connection is
successfully established, the IP address will be added automatically.
Figure 3. Network Settings Menu
4. Select the Advanced tab. This will take you to the advanced network settings menu, shown in Figure 4.
Figure 4. Advanced Network Settings