User manual

DS1093-039 43
9.5 DETECTING VIDEO TAMPERING
Video tampering (i.e. moving camera to a different position) can also be detected and set to trigger an action on your
DVR. To setup video tempering detection:
1. Enter Camera Management/Settings menu by clicking Menu > Setting > Camera.
2. Select camera under Channel # to configure video loss detection for and click the Set button.
3. Select the Advanced tab.
4. Check the Tamper Detection checkbox, as shown in Figure 13.
Figure 13. Camera Settings Menu
5. Click the Area Settings button to enter the area setup.
6. Setup tampering area, as shown in Figure 14. Only one tampering area can be set, with the full screen
being the maximum area.
Figure 14. Tampering Area Setup
7. Set detection sensitivity. The higher the value set, the higher the sensitivity.
8. Click OK to return to the Camera Settings/Management menu.