System information

digiset 5
Urma AG, Switzerland www.urma.ch page 47
8.3.2 Detailed description of measuring procedures
12 detailed measuring procedures have been developed from the main measuring
procedures. Digiset 5 uses these to analyse contours.
The number of different measuring possibilities is, of course, significantly higher be-
cause the measuring procedure can be carried out in each individual quadrant.
You access this operating mode using the following menu steps:
Main menu Sub-menu 1 Sub-menu 2
Imaging
Ö
Measure method
Ö
M0: Automatic
M1: L1
M2: L2
M3: PX
M4: PZ
M5: L1-PX
M6: L2-PX
M7: L1-PZ
M8: L2-PZ
M9: L1-L2
M10: L1-L2-PX
M11: L1-L2-PZ
M12: PX-PZ
Procedure Brief explanation
• M0: Automatic
The procedure used is determined by the TCAM2
• M1: L1
Line 1 measurement
• M2: L2
Line 2 measurement
• M3: PX
Point X measurement
• M4: PZ
Point Z measurement
• M5: L1-PX
Line 1 and point X measurement
• M6: L2-PX
Line 2 and point X measurement
• M7: L1-PZ
Line 1 and point Z measurement
• M8: L2-PZ
Line 2 and point Z measurement
• M9: L1-L2
Line 1 and line 2 measurement
• M10: L1-L2-PX
Line 1 and line 2 and point X measurement
• M11: L1-L2-PZ
Line 1 and line 2 and point Z measurement
• M12: PX-PZ
Point X and point Z measurement
When fixing the line and angle markings light/dark borders are
seen going counter-clockwise from the positive X axis. Line 1 is
shown as the light to dark border within the analysis window. Line
2 is set as the dark to light border.
If Digiset 5 cannot use any of the measuring procedures for the
contour detected, the test LED in the upper left corner of the
screen will be red. The measuring results are then incorrect! .