System information

digiset 5
Urma AG, Switzerland www.urma.ch page 3
Table of contents
1 IMPORTANT NOTES _______________________________________________ 5
1.1 DELIVERY SCHEDULE _____________________________________________ 5
1.2 PURPOSE ______________________________________________________ 6
2 SAFETY INSTRUCTIONS ___________________________________________ 7
2.1 GENERAL SAFETY INSTRUCTIONS_____________________________________ 7
3 COMPATIBILITY STATEMENT _______________________________________ 8
3.1 E
LECTROMAGNETIC COMPATIBILITY (EMC) _____________________________ 8
4 SETUP INSTRUCTIONS ____________________________________________ 9
4.1 U
NPACKING AND START UP _______________________________________ 9
4.1.1 Unpacking______________________________________________________________ 9
4.1.2 Assembling and setup of Digiset 5 __________________________________________ 10
4.2 CALIBRATION OF PRESETTER ______________________________________ 12
4.2.1 Set the camera’s working distance ________________________________________ 12
4.2.2 Check illumination ____________________________________________________ 13
4.2.3 Align camera ________________________________________________________ 15
4.2.4 Adjust X- and Z-Parallelity ______________________________________________ 16
4.2.5 Set absolute zero point ________________________________________________ 17
5 COMMISSIONING ________________________________________________ 18
5.1 OPERATING DIGISET 5____________________________________________ 18
5.1.1 Menu bar (Main menu) ___________________________________________________ 19
5.1.2 Live picture ____________________________________________________________ 20
5.2 STATUS FIELD__________________________________________________ 22
5.2.1 Status and system information _____________________________________________ 22
5.2.2 Various methods of displaying readings on the TCAM2__________________________ 23
6 CONFIGURATION (SOFTWARE SETUP)______________________________ 25
6.1 I
NFO_________________________________________________________ 25
6.2 IMAGING ______________________________________________________ 26
6.2.1 Coordinate system (optional) ______________________________________________ 26
6.2.2 Black/White____________________________________________________________ 26
6.2.3 Brightness (optional)_____________________________________________________ 27
6.2.4 Inverse tool ____________________________________________________________ 27
6.2.5 Imaging parameters _____________________________________________________ 27
6.3 SERIAL INTERFACE (COUNTER MODULE) _______________________________ 28
6.4 OUTPUT FORMAT _______________________________________________ 29
6.5 MEASURING SYSTEMS ____________________________________________ 30
6.6 CORRECTIONS _________________________________________________ 31
6.6.1 Linear correction (optional)________________________________________________ 31
6.6.2 Parallel correction_______________________________________________________ 31
6.6.3 Absolute zero point (optional)______________________________________________ 31