Instruction Manual

Unit ARMED
(BLUE LED ON)
but don’t execute
trig command
Red front led ON
Green front led is OFF
Wires error
Mains power overload
Electronic Board overheath
Bag changed, reset needed
Follow instructions Paragraph 13
Empty bag - replace it following instructions
on Paragraph 13
Unit still warming, wait max 120min. with the unit
connected to the mains power for 1st time
activation
Try a complete power down (mains and battery)
to recover unit.
With no results board needs to be replaced
Clean side air flow holes
Verifify to have 12V beetween ARMP and ARMN
when alarm panel is active.
Verifify to have 12V beetween TRGP and TRGN
when alarm is ON.
Wires errorUnit cannot be ARMED
BLU LED OFF
DEFECT FOUND POSSIBLE CAUSE POSSIBLE SOLUTION
17