INSTALLATION AND USE MANUAL MODULAR PLUS Series ENGLISH MANUAL Installation and use manual model MODULAR PLUS rev.
WARNING! All UR FOG fogging systems should only be used with UR FOG-branded fluids. It is strictly forbidden to use any fluid not previously authorized in writing by UR FOG srl.
02 INTRODUCTION OF THE PRODUCT Thank you for purchasing a UR Fog product The great patented technological innovations such as the moduled liquid injection system, the revolutionary heating system, and the ActiveCloud ready technology make the Modular CPlus fog generators the best fog devices with the best performance in the security market. Simple: Machine easy to install and able to be integrated to any existing alarm system.
04 INSTALLATION TIPS FOR FOGGING SYSTEMS Please observe the following instructions for installing UR Fog: 1. The unit must be installed avoiding to obstruct escape routes. 2. Verify the fog does not limit the visibility near: stairs, landings, moving objects that may cause: falls down, injuries or any damage to persons. 3. Do not look directly into the nozzle. Use only authorized fluids and original bags. 4. The heather box may reach high temperatures, touch it may cause burns. 5.
05 TECHNICAL SPECIFICATIONS Weight without bag MODULAR 2 PLUS MODULAR 3 PLUS MODULAR 4 PLUS MODULAR 5 PLUS MODULAR 8 PLUS 8 Kg 9 Kg 10 Kg 10 Kg 11 Kg 3 3 3 3 500 m 800 m3 1200 m3 1500 m3 2400 m3 750 ml 750 ml 750 ml 1000 ml over 1 hour over 1 hour over 1 hour over 1 hour Average power consumption during heating 170 W + 10 170 W + 10 280 W + 10 280 W + 10 280 W + 10 Heating time about 1,5 hour about 1 hour about 1 hour about 2 hours about 2 hours Average power consump
06 HOW TO ACTIVATE THE SYSTEM To avoid injuries please securely fix the fogging machine to the wall according to the installation instructions. It is recomended not to install the machine behind walls in a limited void without a specific ventilation, in order to prevent a possible overheating. CAUTION: It is always recommended to fix the fog generator to a solid wall even when it is placed on a flat surface.
07 POWER SUPPLY CONNECTION Mains power (115V or 230V ) source supplies energy to the heating system and to the internal power supply. A VRLA 12V 2.0Ah battery (not included) must be connect to the recharge circuit to allow unit to shoot even without mains power. At the heating startup the power consumption is maximum and in a couple of hours it goes down. The average consumption range is from around 37 W (Modular 2) to 53 W (Modular 8).
While connecting the machine to the mains power, it is raccomended to never disconnect existing ground cable. The fact of disconnecting or modifing existing cables voids the warranty and can cause troubles or accidents related to the temperature control. 08 DESCRIPTION OF INPUT AND OUTPUT CONNECTIONS Discrete signals port The discrete signal port is hosted on a multiple way screwed connector, visible on the right side of Fig. 1. In Tab.
09 SHOOTING TIME SETTING To set the shooting time, after removing the plastic front cover, in the middle of PCB is located the FIRETIME (S2) button. By holding down the button, the 3 coloured front leds will flash and the buzzer emit an acustic signal, each flash/beep is equivalent to one second of fog emission from the device. By pressing the button again, the shooting time is not added to the one previously set, but will restart the count from zero.
SHOOTING TABLE MODULAR 2 PLUS (max 28 sec.) m³ to protect Seconds of emission m³ to protect Seconds of emission 25 (75*) 7 100 (300*) 14 75 (225*) 9 150 (450*) 21 m³ to protect 200 (600*) Seconds of emission 28 SHOOTING TABLE MODULAR 3 PLUS (max 40 sec.
11 CONNECTION EXAMPLES Modular Plus family fogging systems are designed to be simply connected to any existing Alarm Panel available on the market. In compliance to the existing rules and for security purpose the activation of the fog emission should be as a result of a “double confirmation” input.The meaning of the “ARM” signal is to be intended as a 1st confirmation.
12 FLUID-INSTALLATION, EXCHANGE AND BAG RESET Insert the fluid container into the compartment as shown in the picture Metal plug Connect the female metal plug connector to the fluid in let hose male connector until you hear the “click” of the metal plug (pictures above), then close the unit’s plastic cover. Press and hold the RESET button until a “beep” is emitted from the buzzer.
13 FRONT LED INDICATORS EMPTY BAG ARMED AND READY WARMING RED LED (right) ON: Error (Empty bag or low fluid , Mains power off/Battery low) or Fault OFF: No error BLU LED (center) ON: Unit is armed and ready to shoot (with green led ON). OFF: Unit is disarmed, shot not possible.
14 MAINTENANCE UR FOG fogging systems don’t need special maintance, nevertheless is suggested a periodical check to the following parts by skilled operators: 1) Verify battery and power supply status. 2) Verify screws are firmly closed. 3) Verify the output nozzle is not damaged and without anyting inside. 4) Verify pneumatic circuit. 5) Verify once a year liquid pump.
15 FAULT-DEFECTS POSSIBLE SOLUTION DEFECT FOUND POSSIBLE CAUSE POSSIBLE SOLUTION Small fog flow coming out from nozzle All products are 100% tested before shipping and a small ammount of liquid could be still in the warming unit This condition is normal and can happen on first installation, it will completely disappear in a while when the unit will become completely hot.
DEFECT FOUND POSSIBLE CAUSE Red front led ON POSSIBLE SOLUTION Bag changed, reset needed Follow instructions Paragraph 13 Empty bag - replace it following instructions on Paragraph 13 Unit ARMED (BLUE LED ON) but don’t execute trig command Unit cannot be ARMED BLU LED OFF 17 Green front led is OFF Unit still warming, wait max 120min. with the unit connected to the mains power for 1st time activation Wires error Verifify to have 12V beetween TRGP and TRGN when alarm is ON.
16 WARRANTY The warranty of UR Fog is two years and is handled directly from the dealer or authorized installer, so please contact your supplier to take advantage of warranty with the copy of the purchase document that contains the serial number of the machine. Not included in the warranty: moving parts and/or damages depending on the incorrect use unless it is found a manufacturing defect in origin. Liquid and bags are not covered by warranty.
17 MAINTENANCE DATE BATTERY EXCHANGE BAG EXCHANGE YES NO n. NO YES NO n. NO YES NO n. NO YES NO n. NO YES NO n. NO YES NO n. NO YES NO n. NO YES NO n. NO YES NO n. NO YES NO n. NO YES NO n. NO YES NO n. NO YES NO n. NO YES NO n. NO YES NO n. NO YES NO n. NO YES NO n.
N.B. Ask for the PDF module writing to: support@urfog.com TO USE UR FOG FOGGING SYSTEMS WITH PURIFOG/PURIFOG HYPO FLUIDS FOLLOW THE DATASHEETS INSTRUCTIONS AVAILABLE FOR DOWNLOAD ON WWW.PURIFOG.COM UR Fog S.r.l.
