Apolloâ Model SL10 Series Audio Selector Panel User’s Guide December 2001 560-0973-00a
No part of this document may be reproduced in any form or by any means without the express written consent of UPS Aviation Technologies, Inc. UPS Aviation Technologies, Inc., II Morrow, and Apollo are trademarks of UPS Aviation Technologies, Inc. © 2001 by UPS Aviation Technologies, Inc. All rights reserved. Printed in the U.S.A. UPS Aviation Technologies, Inc. 2345 Turner Road, S.E. Salem, OR 97302 U.S.A. Toll Free 800.525.6726 Canada Toll Free 800.654.3415 International 503.391.3411 FAX 503.364.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System User’s Guide Table of Contents Section I - General Information ...................................................... 1 1.1 SCOPE ...................................................................................... 1 1.2 Audio Selector (All models) ..................................................... 1 1.2.1 Speaker Amplifier ........................................................... 2 1.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System User’s Guide
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System User’s Guide Section I - General Information 1.1 SCOPE This section provides detailed operating instructions for the UPS Aviation Technologies SL10, SL10S, SL10M, SL10M-S, SL10C, SL10S-C, SL10M-C, and SL10M-S-C Audio Selector Panel/Intercom Systems. Please read it carefully before using the equipment so that you can take full advantage of its capabilities.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System User’s Guide 1.2.1 Speaker Amplifier The "S" in the push-button section stands for speaker. This switch will place all selected audio on the cockpit speaker when this switch is selected. NOTE: with the exception of unswitched unmuted inputs (Altimeter warning), the speaker amplifier is not active in the "Split Mode.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System User’s Guide 1.3.1 Swap Mode (Switch from Com 1 to Com 2 remotely) With a yoke mounted, momentary switch, the pilot can change from the current Com transceiver to the other by depressing this switch. When "Swap Mode" is active, an LED annunciator will illuminate, indicating that the Mic Selector switch position is no longer valid.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System User’s Guide accessed by the avionics technician. Most general aviation headsets have a built-in volume control, so volume can be adjusted “locally.” 1.5.2 Volume Control, Stereo, (SL10S, SL10MS) The volume control knob adjusts the loudness of the intercom and music for the pilot and copilot only. It has no effect on selected radio levels or passengers' level.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System User’s Guide 1.5.4 Adjusting the VOX- Squelch control, Stereo (SL10S, SL10MS) The stereo versions of the SL10 incorporate a single VOX Squelch control for all positions. Like all UPS Aviation Technologies intercoms, since the number of microphones active at any one time is reduced, the unwanted background noise in the headphones is diminished. This also allows the use of dissimilar headsets with the same intercom.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System User’s Guide 1.5.5.1 Soft Mute (Mono) Soft Mute must be enabled during installation by jumpering top connector pins 12 and N. A SPST switch can be installed between these pins for a pilot selectable mute mode. Without this connection, music is not muted during intercom activation. This “Karaoke Mode” prevents the music muting when a sing-along is desired. "Soft Mute" mode only applies to entertainment input #1.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System User’s Guide Table 1 Intercom Modes Mod e Isola te Pilot Hears A/C Radio Pilot Sidetone (during radio transmissi on) Copilot Hears Passenger Hears Comments Copilot and passenger intercom Entertainment #1 Passenger and Copilot intercom Entertainment #1 All Pilot Copilot A/C Radio Passenger s Entertainm ent #1 Copilot Pilot A/C Radio Passengers Entertainment #1 Passengers Pilot Copilot A/C Radio Entertainment #1 Crew P
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System User’s Guide The same pins are used for both mono and stereo SL10 Systems. This applies ONLY to units with applicable serial numbers. 1.6 Marker Beacon (SL10M, SL10M-S The optional Marker Beacon Receiver uses visual and audio indicators to alert you when the aircraft passes over a 75 MHz transmitter. The Blue lamp, labeled "O," is the Outer Marker lamp and has an associated 400 Hertz 'dash' tone.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System User’s Guide If using an external marker receiver, the audio input is lower connector, pin 11 (Aux. input). 1.6.3 Receiver Sensitivity Although the SL10M meets FAA TSO-C35d sensitivity specifications, the sensitivity of the receiver has been adjusted to meet real world requirements (150mV and 1400mV Soft).
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System User’s Guide Section II- Warranty and Service 2.1 Warranty In order for the factory warranty to be valid, the installations in a certified aircraft must be accomplished by an FAA- certified avionics shop and authorized UPS Aviation Technologies dealer. An FAA Form 337 must also be accompanied by the warranty card for this warranty to be in effect.
560-0973-00a December 2001
