Installation manual

UPS Aviation Technologies
SL10 Series Audio Selector Panel and Intercom System
Installation Manual
1-3
Factory adjusted to 1400mV (Soft)
High: 160 mVolts (Hard)
Factory adjusted to 150mV (Soft)
Selectivity: -6 dB at 110 kHz -40 dB at 120 kHz
External Lamp Output: 9.0 (+/- 0.5) VDC Positive when active, max. current 125 mA
MM Sense: Active high (4.7 VDC +/- 0.5V) during Middle Marker
acquisition, for autopilot use.
1.6 EQUIPMENT SUPPLIED
A. 1 ea. of the following units:
Model Part Number
SL10 430-6060-10
SL10S 430-6060-30
SL10M 430-6060-20
SL10MS 430-6060-40
B. SL10 Installation Kit:
Part Number Description Quantity
Stereo
Quantity
Mono
120-425-4402 Top Connector, Stereo (key 4/5) 1 x
120-425-4401 Top Connector, Mono (key 2/3) x 1
120-425-4400 Bottom Connector (key 7/8) 1 1
425-001-0001 Gold Plated Crimp Pins 75 75
701-015-0015 15 Watt Dropping Resistor
(Recommended for 28 Volt Systems)
11
200-066-0003 Operator's and Installation Manual 1 1
1.7 EQUIPMENT REQUIRED BUT NOT SUPPLIED
A. Speaker, 4 W
B. Headphones, 150 W stereo (SL10S) or mono (SL10MS), up to 6 as required
C. Microphones, up to 6 as required
D. Marker Antenna (75 MHz, VSWR <1:1.5, and appropriate for the airspeed)
E. Interconnect Wiring
F. Headphone Jacks (As Required)
G. Microphone Jacks (As Required)
H. Circuit Breaker: 1 ea. 2 amp.
1.8 LICENSE REQUIREMENTS
None