Apolloâ Model SL10 Series Audio Selector Panel Installation Manual December 2001 560-0978-00
No part of this document may be reproduced in any form or by any means without the express written consent of UPS Aviation Technologies, Inc. UPS Aviation Technologies, Inc., II Morrow, and Apollo are trademarks of UPS Aviation Technologies, Inc. © 2001 by UPS Aviation Technologies, Inc. All rights reserved. Printed in the U.S.A. UPS Aviation Technologies, Inc. 2345 Turner Road, S.E. Salem, OR 97302 U.S.A. Toll Free 800.525.6726 Canada Toll Free 800.654.3415 International 503.391.3411 FAX 503.364.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual Table of Contents Section I GENERAL INFORMATION................................................................................................ 1-1 1.1 INTRODUCTION......................................................................................................................... 1-1 1.2 SCOPE ................................................................................................................
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual 3.5.6 Push to talk intercom mode ................................................................................................. 3-4 3.6 Marker Beacon (SL10M, SL10M-S.............................................................................................. 3-5 3.6.1 Middle Marker Sense........................................................................................................... 3-5 3.6.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual Section I GENERAL INFORMATION 1.1 INTRODUCTION The SL10 family of Audio Selector Panels are revolutionary products. Never before has there been so much capability and utility in such a compact package. These units are designed for ease of use and installation, as well as to facilitate cockpit resource management and improve passenger entertainment.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual 1.4 APPROVAL BASIS - FAA TSO Approval. The SL10 and SL10S, Audio Selector Panels are FAA approved under TSO C50c (Audio Amplifiers). The SL10M and SL10MS are FAA approved under TSO C50c and TSO C35d (Marker Beacon Receivers). All systems comply with RTCA DO-143, DO-160b and DO-170. Operation is subject to the following conditions: 1. This device may not cause harmful interference. 2.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual Factory adjusted to 1400mV (Soft) 160 mVolts (Hard) Factory adjusted to 150mV (Soft) -6 dB at 110 kHz -40 dB at 120 kHz 9.0 (+/- 0.5) VDC Positive when active, max. current 125 mA Active high (4.7 VDC +/- 0.5V) during Middle Marker acquisition, for autopilot use. High: Selectivity: External Lamp Output: MM Sense: 1.6 A. EQUIPMENT SUPPLIED 1 ea. of the following units: Model SL10 SL10S SL10M SL10MS B.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual Section II -Installation 2.1 GENERAL INFORMATION 2.1.1 SCOPE This section provides detailed installation and interconnect instructions for the UPS Aviation Technologies SL10-Series Audio Selector Panel/Intercom System and SL10M-Series Audio Selector Panel/Intercom System with internal Marker Beacon.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual 2.3.3 Mounting Rack Installation 2.3.3.1 Monaural (SL10, SL10M) Remove the unit from the mounting tray by first removing the copilot volume and squelch knobs (the knobs are press-fit on the shaft) and then unscrew the 3/32-inch hex-head screw that is to the right of the copilot control knob shaft. Carefully slide the unit free of the tray. Set the unit aside in a safe location until needed.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual 2.4.2 Entertainment Input 2.4.2.1 Monaural (SL10, SL10M) Two entertainment devices (CD player, cassette player, etc.) can be connected to the unit. Install two 1/8inch stereo jacks in a convenient location so that the pilot can plug in the entertainment devices into the system.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual 2.4.3 External Push-to-Talk An important part of the installation is the PTT (Push-To-Talk) switches that allow the use of your aircraft communications radio for transmissions. There are three typical configurations that can be used. Select the case that best fits the installation. Only the person who presses their PTT switch will be heard over the radio.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual located at the lower right hand side of the unit face will automatically adjust the backlight of the pushbutton lamps as well as the rotary mic selector switch light intensity. 2.4.9 Speaker Loads Certain VHF Nav/Comms, such as King KX170-series have internal speaker amplifiers. These are not used with a SL10, but must be loaded to prevent unit failure.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual Adjustment Clockwise Results In Cabin Speaker Level Increase Speaker Volume Marker Beacon Level Decrease Marker Volume MKR Gain Increase overall sensitivity MKR High Sense Increase sensitivity MKR Low Sense Increase Sensitivity Pass. Headphone (Mono or L & R) Louder To make the necessary adjustments, use a small jeweler's slotted screwdriver. Figure 2-1 Adjustments 2.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual 2.9 Post Installation Checkout After wiring is complete, verify power is ONLY on pin 20 of the bottom connector, and airframe ground on bottom connector pin Z. Failure to do so will cause serious internal damage and void UPS Aviation Technologies's warranty. 2.9.1 Operational Checkout, SL10 1. Apply power to the aircraft and avionics. 2. Plug headsets into the pilot, copilot and passenger positions. 3.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual and balance computation and other documentation as required. Return completed warranty registration application to UPS Aviation Technologies.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual Section III OPERATION GENERAL INFORMATION 3.1 SCOPE This section provides detailed operating instructions for the UPS Aviation Technologies SL10, SL10S, SL10M, SL10M-S, SL10C, SL10S-C, SL10M-C, and SL10M-S-C Audio Selector Panel/Intercom Systems. Please read it carefully before using the equipment so that you can take full advantage of its capabilities.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual In SL10-series units, Serial Number T03092 and above, when switching the mic selector rotary switch from COM 1 to COM 2, while COM 2 audio had been selected, Com 1 audio will continue to be heard. This eliminates the pilot having to switch Com 1 audio back on, if desired. When switching from COM 1 to COM 2 while Com 2 has NOT been selected, Com 1 audio will be switched off.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual 3.5.2.1 Mono headsets in Stereo Installation All passenger headsets are connected in parallel. Therefore, if a monaural headset is plugged in to a SL10 Stereo installation, one channel will be shorted. Although no damage to the unit will occur, all passengers will lose one channel. 3.5.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual 3.5.5.2 Soft Mute (Stereo) Both entertainment devices have the "Soft Mute" mode. In units earlier than a “G” intercom board serial number (second set of numbers), only entertainment input #1 has the mute inhibit capability. "Soft Mute" mode for the Crew positions (Entertainment 1) can be selected by pressing in the Volume control knob once.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual 3.6 Marker Beacon (SL10M, SL10M-S The optional Marker Beacon Receiver uses visual and audio indicators to alert you when the aircraft passes over a 75 MHz transmitter. The Blue lamp, labeled "O," is the Outer Marker lamp and has an associated 400 Hertz 'dash' tone. The lamp and tone will be keyed at a rate of two tones/flashes per second when the aircraft is in the range of the Outer Marker Beacon.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual Section IV- Warranty and Service 4.1 Warranty In order for the factory warranty to be valid, the installations in a certified aircraft must be accomplished by an FAA-certified avionics shop and authorized UPS Aviation Technologies dealer. If the unit is being installed by a non-certified individual in an experimental aircraft, a factory-made harness must be used for the warranty to be valid.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual Appendix A External PTT Hook Up Part of the installation includes the installation of PTT (Push To Talk) switches that allow the use of your aircraft radio for communications transmissions. There are three configurations that can be used, you must select the case that best fits your installation. NOTE: Only the person who presses their PTT switch will be heard over the radio.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual Appendix B- Installation Drawing Cutout size for front mount installation 1.62 in (41.15 mm) 6.31in (160.3 mm) 6.65 in (167 mm) Side View 0.60 in (15.25 mm) CG 0.35 in (8.9 mm) 1.31 in (33.27 mm) 3.00 in (76.2 mm) 5.25 in (133.4 mm) 0.8 in (20.3 mm) 6.28 in (159.5 mm) Rear View Weight: 1.5 lb with tray and connectors ( .
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual Appendix C Bottom Connector wiring, Mono and Stereo (see note 9) BOTTOM CONNECTOR 9 Com 1 Audio Hi Communications Transceiver #1 Com 1 Lo Com 1 Mic Audio Hi Com 1 Mic Key Com 1 Spr Load Com 1 Spr Load Com 1 SPR Load See Notes 6, 8 10 Com 2 Audio Hi Communications Transceiver #2 P R 19 L Com 2 Lo Com 2 Mic Audio Hi Com 2 Mic Key Com 2 SPR Load Com 2 Spr Load Com 2 Spr Load Communications Transcei
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual Appendix D Top Connector wiring (Mono), SL10, SL10M Top Connector (monaural) 3 C Copilot Phones Hi Notes: Copilot Phones Lo 1 Pass. Phones Hi A Pass. Phones Lo 5 E Pass. Mic Hi 6 F Pass. Mic Hi 7 H Pass. Mic Hi 8 J Pass. Mic Hi 1. All shields should be grounded at audio panel only. other end remains floating. 2. All phone and mic jacks must be floating from ground. 3.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual Appendix E Top Connector wiring, (Stereo) SL10S, SL10MS TOP CONNECTOR (Stereo) Pilot Phones (L) -see bottom connector. 1 3 2 B Copilot Phones Lo Pass. Phones (R) 4 D Pass. 1 Mic Hi 5 E Pass. 2 Mic Hi 6 F Pass. 3 Mic Hi 7 H Pass. 4 Mic Hi 16 15 T 14 13 R 10 1. All shields should be grounded at audio panel only. other end remains floating. 2. All phone and mic jacks must be floating from ground.
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual Appendix F -Instructions for Continuing Airworthiness and FAA Form 337 Sample ICA Checklist for UPS Aviation Technologies Audio Panels: Section 1 Introduction Item 2 Description 3 4 5 6 Controls Servicing Maintenance Instructions Troubleshooting 7 Removal and replacement information 8 9 10 11 12 13 14 15 16 Diagrams Special Inspection Requirements Protective Treatments Structural Data Special Tools
UPS Aviation Technologies SL10 Series Audio Selector Panel and Intercom System Installation Manual Appendix G RTCA DO160B Environmental Qualification Form Audio Selector Panel/Intercom/Marker Beacon Receiver Part Number: 6000, 6000M, 6000MC, SL10S, SL10MS 6000M-S-C FAA TSO Number: C50c, C35b Class A Manufacturer: PS Engineering Incorporated 9800 Martel Road Lenoir City TN 37772 Conditions Conducted Tests Section Temperature and Altitude Low Temperature High Temperature Altitude Temperature variation Humid
560-0978-00 December 2001
